Symphony W68 Auto Recovery Mode Problem Auto Factory Mode Solution

Symphony W68 Auto Recovery Mode Problem Auto Factory Mode Solution

recovery  in Symphony W68 can be due to Volume key  broken damage and due to water damages.in case of factory mode mobile can not sulve and may it shows power on auto recovery mode condition you can only see recovery signe in mobile but it will not sulve any try in it.

Hints to fix Symphony W68 auto recovery mode problem:

1. Check the auto show recovery assembly for possible damaged and or misaligned. Use a volume key check i, replace it.

2. If the volume key is okay, check and clean the cpu. each certain components where it is being connected.  

4. Check and replace the filter capacitor and resistor components.

5. If the above method doesn't fix the problem, the possible defective part is the MTK chip.

Reworking or replacing  it might only fix the problem, 

That's it., Enjoy!

It's been a long time since I don't have any new post on this blog of mine. Hope, you aren't tired of keep visiting my blog.. www.gsmsolutionking.blogspot.com